NARROWER & STRONGER – 3D PRINTED TANK #7

After a zillion comments telling me this thing is too wide, I reduced its width by 100mm and as I was doing that I decided to reinforce the supports for the suspension and a whole lot of other improvements that will add to the greatness…

Rick Sanchez and Morty Smith and 3D Printers Giveaway!

Thanks to each and everyone of you for subscribing. 2X Tornado, 3X CR-10S, 1X Rick and 1X Morty — Let me know in the comments which one you want! I will randomly, by using a comment randomizer, pick the winners so everyone has the same…

SCREW DRIVE RC TANK #4 THIS IS GETTING BIG!

This thing is getting big! I’ve applied some of your suggestions in the comments and finished the second half. I feel confident about this thing going at least straight, not so sure about turning. I hope I can test it next week. Just in case…

Fusion 360 Tutorial – Learning 3D Sketches – YouTube

I got lots of interesting comments on my wiring tutorial and wanted to take a closer look at using the include 3D geometry feature. I stumbled through this and learned how to work around fusion’s quirks to make a type of wireframe design. If you…