IMAGICLAY.COM

"There are three ways to get something done: do it yourself, hire someone, or forbid your kids to do it."

How To Design 3D Printable Hinged Anything in Tinkercad

Chuck shows you how to use Parametric design in Tinkercad to Design 3D Printable Hinged Anything. He uses the Hinge from Today’s 3D Print Channel and shows you How To Design 3D Printable Hinged objects in a fast and efficient way with Tinkercad. Today’s 3D…

3D Printed Craft Show Display Table Clamp Tinkercad Design

Chuck needed to design a custom craft show display table clamp for his wife. He used Tinkercad to design the table clamp with a set screw for maximum hold. The table clamp is designed to hold dowel rods that support stars above the craft show…

Rebuilding the Spool Racer using Empty 3D Printing Filament Spools

Spool Racer 2.0 is Rebuilding the Spool Racer using Empty 3D Printing Filament Spools and Better Axles. I used stronger sidewall filament spools and a 1/2″ threaded rod for the axles. The original axles were too small and bent causing the thin wall empty 3D…

Winding a 3D Printing Filament Spool with Junk Drawer Parts

I needed to empty a spool for the Spool Racer but wantd to save the filament. So I used an empty spool and my drill to transfer filament from one spool to an empty spool. Quick and dirty solution using parts from my junk drawer….

$300 Creality CR-10 Mini 3D Printer Problems and Updates Review

Chuck was one of the first to show the low cost $300 Creality CR-10 Mini 3D Printer on YouTube and now takes you through the latest version of the $300 Creality CR-10 Mini 3D Printer for Changes, Updates, and Problems. He reviews each change found…

First Look at SeeMeCNC Artemis Delta 3D Printer on Filament Friday

Chuck has Jim Carter visit the Filament Friday Workshop and he brings a special surprise, a SeeMeCNC Artemis Delta 3D Printer. The Artemis is a huge printer that can print wirelessly and quietly. Chuck and Jim go through a first look at the SeeMeCNC Artemis…

How to use Tinkercad Sides Features Improvement on an Original 3D Design

Tinkercad has improved over time and the Filament Friday Chess Pawn Design needed to be improved as well. The design was featured in a Filament Friday video from 2015 and hasn’t been changed since. It was even featured in the book Beginner’s Guide to 3D…

Arduino Autonomous Servo Robot Designed in Tinkercad

Chuck designs a servo robot platform in Tinkercad and then writes the Arduino code in Tinkercad Circuits. The design is autonomous and control by software running on the Arduino. The wheels are driven by two Parallax continuous rotation servos. The design also has expansion plans…

Copyright © 2018 IMAGICLAY.COM